Zepsus Dual Battery Magnetic Switch 7A

Zepsus Dual Battery Magnetic Switch 7amp
  • Weight
    1.8 grams / 0.06 oz
  • Dimensions
    28 x 14 x 6 mm / 1.10 x 0.55 x 0.23 in
  • Features
    Connectors: JR-type
  • Battery config
    For 2-3s Lipo/Liion/LiFe or 4-8s NiMH/NiCD batteries and BEC 5-8.4Volt
  • Voltage
    Input voltage range: 3v~13v
  • Maximum Current
    20A burst
  • Sustained Current
    7A
  • Discharge Rate
    Ultra low stand-by current: 30µA (micro-ampere)
  • $59.95
Qty:  
OR

Zepsus Dual Battery Magnetic Switch 7A

Small, strong and super reliable!

The Dual Battery Magnetic Switch 7A is designed for F5J competition gliders where safety and low weight are important concerns. It is very small, strong, and super reliable due to its redundant design. Dual battery redundancy provides security and peace of mind. The switch automatically selects the battery or BEC with the highest voltage. If the voltage is the same, the power is drawn from both batteries or BEC’s. If one battery or BEC is removed, or there is a short circuit, it will not affect the other battey or the output voltage. 

With this switch, your R/C model can be turned on or off without needing to access it internally. Your model retains the lowest possible surface drag. Just move a magnet over the switch on the outside of the model, and it turns ON. To turn it OFF, just pass the magnet over the switch again. The switch has an ultra-low power consumption in the OFF state. The consumption is so low that the switch can be connected to a 1000mAh battery for several years without discharging it. The switch has a built-in failsafe function. If disconnected from the battery, it remembers its last state for at least 10 seconds. This feature protects the switch against momentary power glitches caused by a bad battery connection, etc.

All switches have been tested with 10 amps for 30 seconds before delivery. Standby consumption is controlled and a visual inspection is made. We recommend the Magnet Holder: LINK

Technical Data

  • Designed for 2-3s Lipo/Liion/LiFe or 4-8s NiMH/NiCD batteries and BEC 5-8.4Volt
  • Input voltage range: 3v~13v
  • Ultra low dropout voltage: 33mV@7A
  • Signal pass-through for one speed controller
  • Output current, constant: 7A @ +25C ambient temperature
  • Output current, burst: >20A
  • Ultra low stand-by current: 30µA (micro-ampere)
  • Wire: high-quality 0.5mm2 / AWG 20
  • Connectors: JR-type
  • Dimensions: 28 x 14 x 6 mm / 1.10 x 0.55 x 0.23 in
  • Weight: 1.8g / 0.06 oz
  • Weight including cables: 11.1 grams / 0.39 oz
  • Length including cables: 27 cm / 10.6 in
  • Operational temperature range: -40C to +85C
Previous image
Zepsus Dual Battery Magnetic Switch 7A
Next image
Zoom image
Customers who bought this product also bought
Customers who viewed this product bought